Seamlock 760 Roof Panel Roll Forming Machine

Material

Effective Width: 1219mm                                Wave Distance Tolerance: ±1mm

Material Thickness:0.6-0.8mm                        Wave Height  Tolerance: ±1mm

Inspection Thickness:0.6mm                           Valid Width Tolerance: ±2mm

Applicable Material: Color Coating                  With Yield Strength: 300Mpa

Test Material: two weeks before the machine trial run, BMS Group  provides the feeding size to the buyer for purchasing.

Work Flow

Uncoiler —
Manual Pre-Cutting — Feed Guide Device — Roll Forming Mill — Hydraulic Post- Cutting Device — PLC Control System -Hydraulic System — Exit Rack

Machine Components

1) Manual
Uncoiler 

Manual control steel coil inner bore shrinkage and stop

Max Feeding Width:1250mm

Coil ID Range:508±30mm

Max capacity:5ton

2) Manual Pre-Cutting

With Manual pre-cutter for easy operation and save material: The pre-cutter
is conneted with PLC control system, PLC is calculating profile length within
roll forming. Once material is required to change, PLC is calculating the length
for total quantity and remind operator,production finishes and able to manual
shearing material before roll forming so as to change material for new production. It
is the advanced function and good for production to save material, avoid wasting.  The rest sheet is continuous formed
by forming system.

3) Roll Forming Machine

Body Base H450 by welding;

The side plate
thickness to adopt the Q235t18mm;

The roller is made
of 45# steel with hard chromium 0.04mm after finishing, Wire drawing polishing
roller

shaft diameter Ø75mm (45# steel);

Gear chain drive,18 Station roll forming;

Main motor 7.5
KW, reducer R series;

Forming speed: 12-15 m/min.

4) Hydraulic  Post Cutter

Post to cut, stop to cutting,Three pieces type of cutting blade design, no blanking;
Hydraulic motor: 3.0KW; Cutting pressure: 0-16Mpa;
Cutting tool material: Cr12Mov (= SKD11 with at least one million times of cutting life), Heat treatment to HRC58-62 degree;
The cutting power is provided by the independent engine hydraulic station (Look Below).

5) PLC Control System

Control The Quantity And Cutting Length Automatically;
Input The Production Data (Production Batch, pcs,Length,etc.) On The Touch Screen;
It Can Finish The Production Automatically;
Combined With: PLC, Inverter, Touch Screen, Encoder, etc.